BFT STOPPY B 700mm electro-mechanical automatic rising bollard

BFT STOPPY B 700mm electro-mechanical automatic rising bollard

Product ID: STOPPYB700

An effective solution for controlling access and providing security to protect domestic properties and vehicles, the BFT Stoppy B 700 is a simple, ready to install and value for money automatic rising bollard.

Electro-mechanical automatic rising bollard
Additional automatic rising bollard for use with BFT STOPPY B Kit 700mm x 200mm electromechanical automatic bollard
230 V
Diameter: 200 mm
Raised Height: 700 mm
Rear-reflecting strip
Impact resistance 6000 J
To be used with Perseo cbd dedicated control panel (not included)

Options for controlling the bollard is:

The Mitto transmitter which can be programmed straight in using the built in receiver (sold separately)
Loop detectors for vehicles (sold separately)

Single bollard unit only

£2,285.00 ex. VAT

ex. VAT

Become a Trade Customer

To receive our best prices on thousands of automation, access control and safety products.

Additional Information

Overview:

Guarantee: 2 years
Opening/closing time: 9 seconds
Usage: semi-intensive

Installation:

Requires a 230v power supply to each panel
Foundation depth Min 1430 mm (including 250mm for drainage) to be concreted below ground with adequate drainage
Foundation box: 1180mm x 273mm x 5mm
High water areas may experience slow water drain-off
Not recommended for sites prone to regular flooding
PERSEO CBD Control panel: Maximum of 4 bollards in parallel on the same system
Distance between bollards should be 1-1.5 metres

Specification

Control unit	PERSEO CBE
Power supply	230 V
Power consumption	300 W
Opening or closing time	9 s
Rod height	700 mm
Rod diameter	200 mm
Type of limit switch	REED magnetic sensor
Slowdown	Yes

Impact resistance	6000 J
Break-in proof	60000 J
Manual cycle	reversible in the absence of voltage
Frequency of use	Semi intensive
Protection rating	IP67
Environmental conditions	-20 ÷ 60 °C
U-Link	no

Imperial measurements

The data shown are for information purposes only.

Control unit	PERSEO CBE
Power supply	230 V
Power consumption	300 W
Opening or closing time	9 s
Rod height	27.55907 inch
Rod diameter	7.87402 inch
Type of limit switch	REED magnetic sensor
Slowdown	Yes

Impact resistance	6000 J
Break-in proof	60000 J
Manual cycle	reversible in the absence of voltage
Frequency of use	Semi intensive
Protection rating	IP67
Environmental conditions	-4 ÷ 140 °F
U-Link	no