IMPORTANT: DUE TO NEW INCREASED SECURITY SETTINGS, IF PAYING BY CREDIT CARD OR DEBIT CARD YOUR BILLING DETAILS MUST MATCH THE NAME ON YOUR CARD AND THE ADDRESS THE CARD IS REGISTERED TO EXACTLY, IF NOT, THE PAYMENT IS LIKELY TO BE DECLINED

Pay in 3 interest-free payments.

Shop Now, Pay with Klarna

Pay in 3 interest-free payments.

Shop Now, Pay with Klarna

GC-22-200N-KIT Gas Gate Closer Kit 50kg up to 1m width

Product ID: GC-22-200N-KIT

Gas Closer kit, for gates up to 1m width and 50kg weight capacity.

The kit includes gas closer, mounting brackets for weld or screw fixings and force adjustment tool.

Learn more about Iwoca here…

£95.00

ex. VAT

£114.00 inc. VAT

Become a Trade Customer

To receive our best prices on thousands of automation, access control and safety products.

Additional Information

Extended length between angle joint centers of 770mm.

The gas gate closer is fixed to the opening side fo the pedestrian gate and is compressed. Be advised to fit a gate stop to limit the gates opening angle at 110 degrees. The gate closer can be damaged by force such as wind or physical movement when fully compressed open.

The closing force can be reduced by using one of the post bracket mounting holes nearer to the gate post, from a choice of 3. Either weld or screw the bracket on to the gate post.

If the closing force is still too high it can be reduced by releasing some nitrogen gas from the cylinder. Please speak to our technical team prior to this, the AT-10 adjustment tool is required.

Specification

Installation Video https://youtu.be/060REoFYrWw

Installation Instructions:

1. Fix the long bracket to the gate post with the dimensions detailed in the Recommended Installation.
2. Fix the small bracket to the gate. Ensure there is a distance of 740mm from the center of the furthest post bracket hole to the center of the gate bracket hole and the brackets are horizontally aligned.
3. Compress the gate closer and connect to the brackets. The speed adjustment end connects to the small gate bracket.

Do not compress the mounting brackets by overtightening the nyloc nuts.
Only tighten the nuts until level with end of bolt, the bolt must not protrude from the nut.

This allows the gate closer to tilt slightly and prevents stress on the connecting parts.