AES EL00C E-loop commercial loop only for exit mode

All Eloop range require a 12V-1A-PSU for power supply, can not be wired direct to the gate automation control panel for power.

These detections are transmitted to a nearby transceiver for gate activation. After the vehicle is detected, the e-loop will switch to radar mode.

The sensors are installed on the surface of entry or exit passages using dynabolts, contain four replaceable Lithium batteries, and can withstand almost any vehicle.

Note: Gate or door controller must have a dedicated open input and auto close function enabled

Quick and easy installation.

• Compact profile – only 26mm high x 200mm diameter.
• Not affected by ground movement.
• 10600 mA battery giving up to 10 years battery life
• High security 128 bit encryption.
• Static load capacity 2500kg.
• Range up to 50 meters.
• Made of high impact plastic

Installation in 3 simple steps

1 – Code in e-Loop.
2 – Secure e-Loop to the driveway.
3 – Calibrate e-Loop and you’re ready to operate in less than 15 minutes. Save many hours of installation time compared to wired loop systems.