ABLE V2 16Y004 180 Degree chain kit

INSTALLING

After checking the exact opening of the wing, it is necessary to make the following changes:
1. Cut the plate on which lays the lid from the foundation box
2. Replace the motor arm with the specific pinion
3. Fix the pinion to the motor reducer shaft by means of the supplied pin and screw: introduce the pin by means of a rubber hammer and tighten the screw
4. Fix the foundation box and the motor reducer as indicated in the handbook (do not tighten the bolts fixing the motor)
5. Replace the transmission lever with the ring gear lever
6. Place the chain round the two cog pinions
7. Open or close the gate in order to make the chain turn round the ring gear of the lever on the shoe.
8. Hook the joint link to close the chain

SETTING UP
Open and close manually the gate and check that the chain is properly tight, then tighten the 4 bolts fixing the motor to the foundation box.
If the chain is too tight or loosen proceed as follows:
1. Widen the 4 fixing holes of the motor reducer up to a maximum of 14 mm
2. Put the motor reducer in the foundation box so that the chain is not too tight or loosen
3. Fix the motor reducer to the foundation box as indicated in the handbook

WARNING: the chain has to be greased at the moment of its installation and periodically upon need